Separate Vhf (75-Ohm) / Uhf (300-Ohm) Antenna; Indoor Vhf/Uhf Antenna - Hitachi VT-M291A Owner's Manual

ANTENNA/CABLE SYSTEM CONNECTIONS
Note to CATV system installer
This reminder is provided to call the CATV system installer's attention to Article 820-40 of
the NEC that provides guidelines for proper grounding and, in particular, specifies that the
cable ground shall be connected to the grounding system of the building as close to the
point of cable entry as practical.

SEPARATE VHF (75-OHM) / UHF (300-OHM) ANTENNA

(1) Disconnect the VHF coaxial antenna cable and the UHF flat twin-lead antenna cable
from the back of your TV set.
(2) Reconnect those cables to a UHF/VHF combiner (not supplied).
(3) Connect end of the UHF/VHF combiner to the ANT.IN terminal of the VCR.
(4) Connect one end of the COAXIAL CABLE (supplied) to the ANT.OUT terminal of the
VCR.
(5) Connect the other end of the COAXIAL CABLE (supplied) to a UHF/VHF separator
(not supplied).
(6) Connect the separator's coaxial end to the TV's VHF jack, and flat twin-lead end to
the TV's UHF terminal.
See Separate VHF/UHF Connection Diagram.

INDOOR VHF/UHF ANTENNA

(1) Disconnect the indoor UHF/VHF antenna cable from the back of your TV set.
(2) Reconnect the cable to the ANT.IN terminal of the VCR.
(3) Connect one end of the COAXIAL CABLE (supplied) to the ANT.OUT terminal of the
VCR.
(4) Connect the other end of the COAXIAL CABLE (supplied) to the antenna/cable jack
of your TV.
20