Advertisement
USER MAINTENANCE AND REPAIR
Disconnect unit from electrical supply before performing any maintenance.
Turn off the water supply at the tap and press the trigger to discharge built up pressure.
Lubricate the fixings periodically using lubrication oil.
When the water pressure is not consistent or is too high, this is a sign of a defective hose or calcium
buildup in the nozzle.
In this event, turn off the machine immediately.
Use the nozzle cleaner to clean the hose and the water inlet filter.
Change the defective filter.
Make sure that the machine is clean by cleaning the components when necessary.
Ensure that you have followed the instructions regarding different parts (ie – pluggable ring-nuts are
used to connect the gun, hose and other parts.)
The seals of the ring-nut connections must be inspected for damage.
Fasten the detergent tank to the foam nozzle securely.
Connect the foam nozzle to the jet gun.
Turn on the machine, mix a mild household cleaning agent at a proportion of 1:10 with water.
Keep the appliance safe and store carefully in a secure dry place. Always store the machine out of
reach of children.
Avoid storing the washer in temperatures below frost point.
Cut off the power if the appliance malfunctions.
Problem
Machine will not start working
Not enough water coming out
or uneven working pressure.
Water leaking from the pump.
Motor stops suddenly.
Probable Cause
1. No power supply.
2. Faulty power supply.
3. Locking ring of pump
too tight.
1. The filter is blocked.
2. Inlet connection is not
good in the inlet pipe.
3. Valve is blocked.
4. Outlet nozzle is not
smooth.
3 drops of water per minute is
permissible, but if more water
is leaking, this may mean the
seal is worn out.
1. Pressure control has
worked.
2. Unit has overheated.
Possible Solution
Contact Kogan customer
support.
1. Clean the filter.
2. Check the connection,
tighten the seal, check
hose for clogging and
ensure there is enough
inlet water.
3. Clean the valve and
install again.
4. Contact Kogan
customer support.
Contact Kogan customer
support.
1. Check if outlet nozzle is
blocked.
2. Turn off cleaner and
allow unit to cool down
for a few minutes.
3. Contact Kogan
customer support.
Advertisement
