Advertisement
Connect to the water supply
The cleaner is not suitable for connection directly to potable water mains.
Connect the machine to the water supply (alternately it can be a water container).
Make sure the inlet water pressure keeps between 0.01MPa and 0.3MPa.
The inlet pipe should be at least 5M long. Do not use the pipe if the pipe is damaged.
If you want to connect the unit to potable water mains, you must install a backflow preverter in the
water pipe to prevent dirty water flowing back into the drinking system. The backflow preventer
must comply with EN 60335-2-79 ANNEX AA.
Overheating protection
The machine has an overheating protection device. It turns the unit off automatically if it overheats,
in which case you should turn off the cleaner and remove the plug from the mains supply. Once the
unit has had some time to cool down, you can switch it back on again.
CAUTION
Some painted or treated surfaces may be susceptible to damage from high pressure cleaning.
Always keep a good distance away from the surface you are cleaning.
USE OF THE APPLIANCE
Connect the pressure hose to the water outlet of the appliance, then connect the jet gun to the other
end of the pressure hose.
Connect the lance to the nozzle.
Check that the filter is clean.
Connect the water hose to the water inlet of the appliance.
Do not bend, twist or fold the hose.
Turn on the water supply at the tap and check the whole machine for any signs of water leakage.
At first, air in the appliance may cause unstable pressure. Discharge the air in the machine by
squeezing the trigger until nothing is coming out.
Connect the plug to the power socket, then turn on the machine. Use two hands to hold the
appliance steady. Squeeze the trigger and then use the high pressure cleaner.
SWITCHING OFF THE UNIT
Turn off the water supply at the tap.
Press the trigger to reduce the pressure in the appliance.
Pull out the water inlet hose, then let the machine run for a few seconds to drain the water that is
still stored in the pump.
Switch off the appliance and disconnect the electric plug from the socket.
Detach the pressure hose. To drain residual water, life up the jet gun and squeeze the trigger.
Advertisement
