Advertisement
Assembly
Before use, please assemble the high pressure cleaner step by step.
First, connect the water feeding pipe to the suction pipe by making use of a stiffened tube, then
connect the other end of the suction pipe to the machines inlet (See fig 1).
Connect the pressure hose to the machine's outlet (See fig 2). The outlet is made of Al-alloy. If the
hole is extremely narrow, you can use some lubrication oil.
Turn the water supply on, making sure the tap is fully open. Check to ensure the whole appliance is
watertight and airtight. Press the gun trigger so that the air and any pressure waste go out from the
piping. Now you can start the equipment up.
WARNING: Do not direct the jet against people, animals or any high voltage wiring. Always
disconnect the appliance from the power supply before you change any parts.
WARNING: User must wear protective clothes before working with the appliance.
After use, make sure the appliance and hose are both dried.
Check the supply voltage. The voltage shown on the rating plate must match the supply voltage.
Use only watertight power plugs and cords, with rubber insulation enclosures.
Inadequate extension cords can be dangerous.
Connect the hose to the jet gun (see fig 4)
Connect the nozzle to the jet gun (see fig 3). Turn the nozzle clockwise until it locks into position,
so the sealing ring is not damaged. All spare parts for the jet gun are equipped with ring-nut
connection. Connect the hose to the machine. Check that the seal ring is properly seated.
Advertisement
