Upc/Ean; Isbn; Gtin Processing; User Reset Factory Defaults - Intermec SF51 User Manual

Turn Off After
Trigger Mode Good Read
Pulse Enabled
Pulse Disabled

UPC/EAN

Enables or disables decoding of Universal Product Code (UPC)/
European Article Numbering (EAN) symbology. UPC/EAN are
fixed-length, numeric, continuous symbologies that use four
element widths. A scanner that is configured to decode EAN bar
codes can decode UPC, but the reverse is not true. UPC code is a
subset of EAN code.

ISBN

ISBN (International Standard Book Number) is a 10-digit
symbology that uniquely identifies books for tracking and
ordering.
With ISBN enabled, the first three characters (978) are ignored,
and the checksum is calculated on the remaining characters.

GTIN Processing

With GTIN (Global Trade Item Number) processing enabled,
two zeros are padded to the beginning of UPC-A, and one zero is
padded to the beginning of EAN-13 to expand the numbers to 14
digits. To use GTIN processing you also need to enable the
corresponding UPC/EAN symbology.

User Reset Factory Defaults

Causes the SF51 to perform a restart and restores all
configuration commands to their default settings, only if no
settings are locked. To reset all settings on the SF51, including
locked settings, use the Administrator Reset Factory Defaults
command. For more information, see
Factory Defaults" on page
When you restore all configuration commands to their default
settings, you need to reestablish Bluetooth communications.
SF51 Cordless Scanner User's Guide
Chapter 4 — Configuration Command Reference
SF51 Behavior
The SF51 turns off after it successfully
reads a bar code.
The SF51 stays on until the Trigger
Timeout period is reached.
"Administrator Reset
38.
51