Chapter 4 — Configuration Command Reference
Command
Configuration modes
and utilities
Bluetooth device page
SF51 Configuration Commands
This section lists the configuration commands in alphabetical
order and provides a description of each command. To configure
your SF51 using these commands, see the EasySet software.
Administrator Reset Factory Defaults
Causes the SF51 to perform a restart and restores all
configuration commands to their default settings. When you
restore all configuration commands to their default settings, you
need to reestablish Bluetooth communications.
Beep Duration
Sets the length of the beeps. You can set Beep Duration to a value
from 0 to 2550 ms. When Beep Duration is set to 0 ms, the
beeper is off. Turning off the beeper does not affect the beeps
associated with Bluetooth Connect/Disconnect or Bluetooth
Device Page.
Use Beep Duration in combination with Beep Frequency and
Beep Volume to define beeps according to operator preference
and work environment.
Beep Frequency
Sets the frequency, or pitch, of the beeps. You can set Beep
Frequency to a value from 1000 to 5110 Hz.
Use Beep Frequency in combination with Beep Volume and
Good Read Beep Duration to define beeps according to operator
preference and work environment.
38
Default Value
Configuration
Enabled
N/A
SF51 Cordless Scanner User's Guide
See Page
43
39