Upc/Ean; User Reset Factory Defaults; Vibrate Alert; Vibrate Alert Duration - Intermec SF51 User Manual

Chapter 4 — Configuration Command Reference

UPC/EAN

Enables or disables decoding of Universal Product Code
(UPC)/European Article Numbering (EAN) symbology.
UPC/EAN are fixed-length, numeric, continuous symbologies
that use four element widths. A scanner that is configured to
decode EAN bar codes can decode UPC, but the reverse is not
true. UPC code is a subset of EAN code.
ISBN
ISBN (International Standard Book Number) is a 10-digit
symbology that uniquely identifies books for tracking and
ordering.
With ISBN enabled, the first three characters (978) are ignored,
and the checksum is calculated on the remaining characters.
GTIN Processing
With GTIN (Global Trade Item Number) processing enabled,
two zeros are padded to the beginning of UPC-A, and one zero
is padded to the beginning of EAN-13 to expand the numbers to
14 digits. To use GTIN processing you also need to enable the
corresponding UPC/EAN symbology.

User Reset Factory Defaults

Causes the SF51 to perform a restart and restores all
configuration commands to their default settings, only if no
settings are locked. To reset all settings on the SF51, including
locked settings, use the Administrator Reset Factory Defaults
command. For more information, see "Administrator Reset
Factory Defaults" on page 40.
When you restore all configuration commands to their default
settings, you need to reestablish Bluetooth communications.

Vibrate Alert

Enables or disables the vibrate alert. When Vibrate Alert is
enabled, the scanner vibrates when you scan a valid bar code.

Vibrate Alert Duration

Sets the amount of time that the vibrate alert remains on. You
can set Vibrate Alert Duration to a value from 0 to 2550 ms.
54 SF51 Cordless Scanner User's Guide