Intermec SF51 Instructions

them tighten and case bottom
cases. two the
the that sure Make cases. bottom
bottom SF51 the in compartment
connector
the Disconnect cable. battery
bend not does PCB the
Instructions
Recycling Information
When the battery reaches the end of its useful life, the
spent battery should be disposed of by a qualifi ed
recycler or hazardous materials handler. Do not mix
this battery with the solid waste stream. Contact your
Intermec Technologies Service Center for recycling or
disposal information.
Note: In the U.S.A., the EPA does not consider spent
Li-ion batteries as hazardous waste.
Worldwide Headquarters
6001 36th Avenue West
Everett, Washington 98203
U.S.A.
tel 425.348.2600
fax 425.355.9551
www.intermec.com
©
2006 Intermec Technologies
Corporation. All rights reserved.
SF51 Battery Instructions
*074650-002*
P/N 074650-002
in-lb). (3 Nm 0.34
the in screws three the Install
between pinched not are cables
and top the close Carefully
case.
the in battery the Place
cable. battery new the Install
battery. the Remove
LED
cable
Battery
place in PCB hold
to here finger Place
Battery
cable. battery
the disconnect you when
so foam the on nger fi your Place
Battery SF51
to
8
7
6
PCB.
bottom and
5
case.
4
in result
equipment
skin
electrostatic
in (PCB)
and warranty
3
The SF51 battery (Model 074211) is a 2400 mAh lithium-ion battery
designed for use in the SF51 Cordless Scanner.
Charging the Battery
You need to fully charge the battery before using it in your SF51.
Batteries can be charged after a partial discharge without aff ecting
the original battery capacity. You can charge the battery with one
of these accessories:
• SF51 1-Bay Charger (Model 074645)
• SF51 4-Bay Charger (Model 074646)
To charge the battery
• Place the SF51 in a 1-bay or 4-bay charger. A fully discharged
battery charges to 100% capacity in approximately 3 hours.
For more information about SF51 charging accessories, see the
instructions that ship with the charger.
the to attached connector
top the separate entirely
bottom SF51 the from screws
components.
may comply to Failure
the of inside working when
the to attached rmly fi straps
wearing always by ESD Prevent
by damage to sensitive
boards circuit printed on
components. internal to
the void will unit the
Battery
SF51 Battery Instructions
Note: It may take longer than the indicated charging
time to charge the battery if the battery is near the
minimum or maximum charging temperature.
places) (3 Screw
LED the Leave cases.
2
not do but open Slowly
1
three the Remove
PCB to damage
housing. equipment
assembly base metal
ground contact
(ESD). discharge
are equipment this
circuits Integrated
damage cause may
Opening Warning:
the Replacing