Spare Parts; Disk Drive Removal; Table 2.1 Model And Parts Numbers - Fujitsu MHV2100BH Maintenance Manual

Removal and Replacement Procedure
2.1

Spare Parts

See Table 2.1 for the model and parts numbers to order the replacement disk drive.
Model Name
MHV2100BH
MHV2080BH
MHV2060BH
MHV2040BH
2.2

Disk Drive Removal

The method and procedures to demount the disk drive to check the jumper
terminal, change the jumper position, or replace the device differ depend on the
system cabinet structure. Therefore, for actual working procedures, the specific
conditions necessary for each system must be determined. The general removal
procedures, with notes, are as follows.
a) Disconnect the power-interface cable.
b) Remove the screws that attach the drive and remove the drive from the
system cabinet.
c) When storing or transporting the drive, pack it an antistatic bag in
compliance with section 1.1.2 (5) d. and (5) e..
To protect the device from damage and prevent the worker getting hurt, observe
the following cautions and precautions in Subsection 1.1.1.
Damage or Device damage
1.
2.
3.
2-2

Table 2.1 Model and parts numbers

Capacity
Mounting screw
(user area)
100 GB M3 Depth 3
80 GB M3 Depth 3
60 GB M3 Depth 3
40 GB M3 Depth 3
Perform any removal after the system power is completely
disconnected. The cable must not be disconnected and the
screws that attach the drive must not be removed with the
power ON.
Do not move the drive and attach or detach the connector until
it comes to a complete stop (about 30 s after the power is
turned OFF).
Perform the human body grounding to discharge any static
electricity from your body. (Be sure to wear a wrist strap)
Order No.
CA06672-B140
CA06672-B148
CA06672-B136
CA06672-B124
C141-F074