Spare Parts; Disk Drive Removal; Table 2.1 Model And Parts Numbers - Fujitsu MHV2080AS - Extended Duty Mobile 80 GB Hard Drive Specification

Removal and Replacement Procedure
2.1

Spare Parts

See Table 2.1 for the model and parts numbers to order the replacement disk
drive.
Model Name
MHV2080AS
MHV2060AS
MHV2040AS
2.2

Disk Drive Removal

The method and procedures to demount the disk drive to check the jumper
terminal, change the jumper position, or replace the device differ depend on the
system cabinet structure. Therefore, for actual working procedures, the specific
conditions necessary for each system must be determined. The general removal
procedures, with notes, are as follows.
a) Disconnect the power-interface cable.
b) Remove the screws that attach the drive and remove the drive from the
system cabinet.
c) When storing or transporting the drive, pack it an antistatic bag in
compliance with section 1.1.2 (5) d. and (5) e..
To protect the device from damage and prevent the worker getting hurt, observe
the following cautions and precautions in Subsection 1.1.1.
Damage or Device damage
1.
2.
3.
2-2

Table 2.1 Model and parts numbers

Capacity
Mounting screw
(user area)
80GB M3 Depth 3
60GB M3 Depth 3
40GB M3 Depth 3
Perform any removal after the system power is completely
disconnected. The cable must not be disconnected and the
screws that attach the drive must not be removed with the
power ON.
Do not move the drive and attach or detach the connector until
it comes to a complete stop (about 30 s after the power is
turned OFF).
Perform the human body grounding to discharge any static
electricity from your body (Be sure to wear a wrist strap).
Order No.
CA06531-B708
CA06531-B706
CA06531-B704
C141-F073