Fujitsu PRIMERGY TX100 S2 Options Manual page 16

Safety instructions
Before starting up
V
CAUTION!
During installation and before operating the device, observe the
instructions on environmental conditions for your device.
If the device is brought in from a cold to a warm environment,
condensation may form both inside and on the outside of the device.
Wait until the device has acclimatized to room temperature and is
absolutely dry before starting it up. Material damage may be caused
to the device if this requirement is not observed.
Transport the device only in the original packaging or in packaging
that protects it from knocks and jolts.
Installation and operation
V
CAUTION!
The device may only be operated at a maximum ambient temperature
of 35°C.
If the device is integrated in an installation that receives power from
an industrial (public) power supply network with the IEC309
connector, the (public) power supply protection must comply with the
requirements for non-industrial (public) power supply networks for the
type A connector.
The unit automatically adjusts itself to a mains voltage in a range of
100 V - 240 V. Ensure that the local mains voltage lies within these
limits.
This device must only be connected to properly grounded shock-
proof sockets with tested and approved power cables.
Ensure that the device is connected to a grounded power outlet close
to the device.
16 Options Guide
TX100 S2