Fujitsu PRIMERGY TX100 S1 Service Supplement Manual page 34

Replacing the power supply unit
– on the side
Figure 19: Chassis - hooks on the side
Ê Insert the pre-mounted power supply unit in the chassis.
I
Make sure that the power supply unit engages.
Ê Secure the power supply unit at the rear of the server with the four screws
(see also figure 15 on page
Ê Connect all power supply cables to the system board and to the drives (see
the cabling in the Options Guide).
Ê Close the server and reconnect the power plug.
34
31).
Service Supplement
Replacement routines
TX100 S1