Connecting To The Water Supply - Electrolux Lavamat 60800 User Information

Connecting to the water supply

Important!
• This appliance must not be connected to the hot water system.
• When connecting it, use only new hose kits.
• Only connect the appliance to the drinking water supply. Rain water
or water for industrial use may only be used if it fulfils the require-
ments of DIN1986 and DIN1988.
• Do not kink or crush the water inlet hose or drain hose.
Permitted water pressure
The water pressure must be at least 1bar (=10N/cm
be a maximum of 10bar (=100N/cm
– If more than 10bar: Connect a pressure reduction valve.
– If less than 1bar: Disconnect the appliance end of the inlet hose from
the solenoid inlet valve and remove the flow meter. (In addition re-
move the filter using pointed pliers and take out the rubber gasket
behind it.) Re-insert the filter.
28
2
=0.1MPa) and may
2
=1MPa).