Direct Numeric Tuning; Automatic Tuning; Selecting Fm Stereo/Mono Modes - Emotiva LMC-1 Manual

EXAMPLE
FREQUENCY 1 1
DOLBY
FM 10 1.5
DTS
TUNER
Tune
Band FM
Auto Tune
Manual Tune +
Manual Tune -
Memory Channel
Frequency Input
Delete Channel
Return

Automatic Tuning

Automatic Tuning from the Remote
Press the "AUTO TUNE" button on the remote control and the LMC-1 will search for all
the broadcasting stations automatically and then populate the memory positions with
each of the "tuned in" stations in ascending frequency order. The front panel display will
show the frequency and the AM or FM designation as you press the "MENU UP/DOWN"
arrow keys to scroll through the stations that were received and stored. It's a great way
to do most of the work of setting the AM/FM presets by the touch of a button, then you
can go back and put in your prime choices in the first couple of positions.
Tune
Band FM
Auto Tune
Manual Tune +
Manual Tune -
Memory Channel
Frequency Input
Delete Channel
Return

Selecting FM Stereo/Mono Modes

You can also select between FM Stereo or Mono modes depending upon your ability
(or inability) to clearly tune in certain stations. If stations are not well received, the
MONO setting may sound better because it will reduce RF interference from the weak
signal. To select between STEREO and MONO settings, simply ensure you are on the
FM band and use the "STEREO" button on the remote control (below AM/FM button) to
toggle between STEREO and MONO modes.
Page 40

Direct Numeric Tuning

Direct Numeric Input from the Remote
From the remote, press "FREQUENCY" at the bottom right
corner and then enter the station frequency numerically. LMC-1
automatically adds a "0" after you press the number "1" as the first
digit so the entry will immediately show "10_" on the front panel
waiting for the next numeric entry.
5
=
For example, if you wanted to input FM station 101.5, the button
sequence would be:
"FREQUENCY", then "1" (which automatically places the "0"),
followed by "1" and "5". See example at left.
Direct Numeric Input from the OSD Menu
From the OSD Input Select menu, choose Tuner, then "Frequency Input".
This function acts just the same as direct frequency input from the remote
control. If the first numeric entry is "1", remember LMC-1 automatically
places a "0" immediately after for the result of "10_" awaiting the next
numeric input.
Automatic Tuning from the OSD
From the OSD Input Select menu, choose Tuner, then "Auto Tune". This
function acts just the same as engaging the AUTO TUNE mode directly from
the remote control.