Brother DCP-7055W User Manual page 57

Note
• The machine makes a mechanical noise
during the Drum Cleaning process
because the machine rotates the OPC
drum in reverse. This noise is not due to a
malfunction of the machine.
• DO NOT put more than one sheet of paper
in the manual feed slot at any one time, as
it may cause a jam.
• If the paper in the manual feed slot is other
than A4 or Letter size, the machine will
stop the Drum Cleaning process and eject
the paper.
• Make sure that the paper is straight and in
the correct position in the manual feed
slot. If it is not, it may not be fed correctly,
resulting in a paper jam.
• DO NOT close the back cover (face-up
output tray) during the Drum Cleaning
process. The machine will stop the Drum
Cleaning process and eject the paper. It
may cause a jam.
• If the machine receives a print job before
you put one piece of paper in the manual
feed slot, the machine stops the Drum
Cleaning process and print the print job.
h
When the machine has finished
cleaning, the machine returns to the
Ready mode.
i
Repeat steps e to h two more times
using a new blank sheet of paper each
time. Upon completion please discard
the used paper.
Routine maintenance
If the problem is not solved yet, follow the
steps below.
a
Open the front cover and leave the
machine turned on for 10 minutes to
cool down.
WARNING
HOT SURFACE
After you have just used the machine, some
internal parts of the machine will be
extremely hot. Wait for the machine to cool
down before you touch the internal parts of
the machine.
A
49