h.
Heat sink (see
i.
Modem module (see
j.
System board (see
Remove the RJ-11 connector cable:
1.
Position the computer right-side up, with the front toward you.
2.
Remove the RJ-11 connector (1) from the clip built into the base enclosure.
3.
Remove the RJ-11 connector cable from the clips and routing channel (2) built into the base
enclosure.
4.
Remove the RJ-11 connector cable from the base enclosure.
Reverse this procedure to install the RJ-11 connector cable.
100 Chapter 4 Removal and replacement procedures
Heat sink on page
76)
Modem module on page
System board on page
92)
97)