15
Inside of cart, insert rear shield tabs into slots next to grease tray opening on upper back panel, shown A.
Attach front shield tabs(with holes) under front brace with two #8x3/8" self-tapping screws, shown B.
front tab
(w/hole)
A
Upper back panel
Cart lower back panel
16
Connect each of the wires from the main burner electrodes, and sideburner electrode into the back of the Electronic Ignition
Module. Total (5) connections, shown A.
Connect the two wires [(a) and (b)] from the switch wiring harness into the back of the Electronic Ignition Module.
Total (2) connections, shown A.
NOTE: Switch terminals are larger than electrode terminals and should only be installed in location shown as (a),(b).
Release the cap and nut from electronic ignition module. Attach electronic ignition module to the cart left side panel with
the nut, shown B
Insert AA battery into ignition module, negative (
A
ignition module
24
Tank heat shield
Grease tray opening
Tank heat shield
Electronic
3
(a)
1
4
2
5
(b)
rear tab
self-tapping screw
-
) end first. Then put on the cap, shown C.
B
Nut
C
Note: some parts omitted
for clarity of illustration
Front Brace
#8x3/8"
-
+
Cap
AA battery
B
Electronic
ignition module