Char-Broil 463269311 Product Manual page 19

7
Attach right side lower fascia to right side upper fascia using three #10x3/8" screws, 5mm lock washers and 5mm flat
washers, shown A.
Remove the three screws and washers which were attached on right side of firebox front, shown B.
Insert flange on right side shelf into side shelf brackets on side of firebox, shown C.
Attach right side shelf front using the two screws and washers which were removed from right side of fire box, shown D.
Attach rear of shelf using one 1/4-20x3/4" screw, 7mm lock washer, fiber washer and 1/4" nut, shown E/F.
Remove the four screws and washers factory attached to the Auto Clean valve bracket. Position Auto Clean valve bracket
beneath right side shelf fascia so that valve stem comes through larger center hole in fascia. Align the four holes on valve
bracket with the four holes on fascia. Secure using screws and washers that were removed from bracket, shown G.
Place the blank bezel over valve stem on front side of the fascia. Align small holes on bezel with the holes on fascia.
Attach using two #8-32x3/8" screws and 4mm lock washers. Press control knob on to valve stem, shown H.
Inside of right side shelf
5mm flat washer
5mm lock washer
#10x3/8" screw
Right side lower fascia (inside)
Fiber washer
1/4-20x3/4"
Screw
7mm lock
Washer
1/4" Nut
B
A
remove
Pliers needed
E
F
Screws and Washers
removed from valve bracket
Valve stem
Auto Clean valve bracket
Side shelf
bracket
Screw
Washer
*Screws and washers
removed from right
side of firebox front.
G
H
Valve stem
Right side shelf
D
Note: Use upper and lower
holes on fascia to
attach bezel
#8-32x3/8"
screw
4mm
lock washer
Bezel (blank)
Control knob
C
19