Using The Remote To Control Vcr Functions - Hitachi 32UDX10S, 36UDX10S Operating Manual

Solid state color tv

Table of Contents

Operating the precoded function for your VCR.

This remote is designed to operate different types of VCRs. You must first program the remote to match the remote system of your

VCR. (refer to page 33 for pre-codes)

Turn ON your VCR.

Aim the remote control at the front of your VCR.

Press and release the VCR button to switch to VCR pre-coded mode.

Hold down the VCR button on the remote and enter the two digit preset code that matches your VCR, as shown on page 33. The

indicator light will flash 3 times if the code was accepted.

Aim the remote at the VCR and press the POWER button. The remote will turn off your VCR when the correct two digit preset code

is entered. When this occurs, the remote control is programmed for your VCR. If the VCR does not turn off, try a different two digit

preset code.

The remote will now control your VCR.

NOTES:

If your VCR cannot be operated after performing the

above procedures, your VCR s code has not been

precoded into the remote.

In the unlikely event that your VCR cannot be operated

after performing the above procedures, please consult

your VCR operating guide.

The remote control will remember the codes you have

programmed until the batteries are removed from the

remote control. After replacing the batteries repeat the

entire programming procedure as stated above.

The MENU button will act as the VCR MENU button for

HITACHI VCRs.

The LAST CH button will act as your VCR ENTER button

if required.

The SLEEP button will act as your VCR 100 button if

required.

VCR Button

This button allows the remote to control your VCR by setting

it to VCR mode.

PRECODED VCR Buttons

These buttons transmit the chosen precoded VCR codes.

For some VCRs, you must press the RECORD button twice

to record a program.

EXCLUSIVE TV Buttons

These buttons are for operating the TV.

Refer to instruction manual of the VCR for operation of the buttons exclusively for the VCR.

NOTE: