Using The Remote To Control Vcr And Cable Box Functions - Hitachi GX Series 27GX01B Operating Manual

0335E2new.fm Page 13 Tuesday, April 25, 2000 4:10 PM

Using the Remote to Control VCR and Cable Box Functions

U SING THE R EMOTE TO C ONTROL VCR AND C ABLE B OX F UNCTIONS
Operating the Precoded Function
for Your VCR
This remote is designed to operate
different types of VCRs. You must first
program the remote to match the
remote system in your VCR. (Refer to
the VCR Code Index section.)
1. Turn on your VCR.
2. Aim the remote control at the front
of your VCR.
3. Press the VCR button to switch to
VCR precoded mode.
4. While holding down the VCR
button, enter the 2-digit preset
code that matches your VCR*. The
remote will turn on your VCR when
the correct 2-digit preset code is
entered. When this occurs, the
remote control is programmed for
your VCR. If your VCR does not
turn off after 5 seconds, try a
different 2-digit preset code.
5. The remote will now control your
VCR.
NOTES:
• If your VCR cannot be operated
after performing the
procedures, this means that your
VCR codes have
precoded into the remote.
• In the unlikely event that your VCR
cannot be operated
performing the above procedures,
consult your VCR operating guide.
• The remote control will remember
the codes you have programmed
in until the batteries are removed.
After replacing the batteries repeat
the entire programming procedure
stated above.
• If your VCR does not have a power
function, the remote will issue the
CHANNEL UP function.
POWER TV
1 2
4 5
7 8
MUTE 0
INPUT SLEEP
MENU
RECALL
above
not been
REC
STOP
tt
TV/VCR
after
HITACHI
CLU-351U
* (Codes are listed on page 14)
- 13 -
Operating the Precoded Function
for Your Cable Box
1. Turn on your cable box.
2. Aim the remote control at the front
of your cable box.
3. Press the cable box button to
switch to cable box precoded
mode.
4. While holding down the CABLE
button, enter the 2-digit preset
code that matches your cable box*.
CABLE VCR
The remote will turn on your cable
box when the correct 2-digit preset
3
code is entered. When this occurs,
CH
the remote control is programmed
for your cable box. If your cable
6
CH
box does not turn off after 5
seconds, try a different 2-digit
9
VOL
preset code.
5. The remote will now control your
LTS-CH VOL
cable box.
NOTES:
CURSOR
• If your cable box cannot be
CONTROL
operated
above procedures, this means that
your cable box codes have not
been precoded into the remote.
• In the unlikely event that your
cable box cannot be operated after
PAUSE
performing the above procedures,
t uu
consult your cable box operating
guide.
• The remote control will remember
the codes you have programmed
in until the batteries are removed.
After replacing the batteries repeat
the entire programming procedure
stated above.
• If your cable box does not have a
power function, the remote will
issue the CHANNEL UP function.
• For some models, the remote
control's channel
control the cable box channel. The
number buttons will control your
television channel although you
are in cable mode.
after performing the
and will