Hitachi 32UDX10S, 36UDX10S Operating Manual page 30

USING THE REMOTE TO CONTROL SATELLITE RECEIVER
Operating the precoded function for your satellite receiver.
This remote is designed to operate different types of satellite systems. You must first program the remote to match the remote system
of your satellite receiver. (refer to page 33)
1. Turn ON your satellite receiver.
2. Aim the remote control at the front of your satellite receiver.
3. Press and release the SATELLITE (SAT) button to switch to satellite pre-coded mode.
4. Hold down the SAT button on the remote and enter the two digit preset code that matches your satellite receiver as shown on page
33. The indicator light will flash 3 times if the code was accepted.
5. Aim the remote at the satellite receiver and press the POWER button. The remote will turn off your satellite receiver when the
correct two digit preset code is entered. When this occurs, the remote control is programmed for your satellite receiver. If the
satellite receiver does not turn off, try a different two digit preset code.
6. The remote will now control your satellite receiver.
NOTES:
1. If your satellite receiver cannot be operated after
performing the above procedures, your satellite receiver
code has not been precoded into the remote.
2. In the unlikely event that your satellite receiver cannot be
operated after performing the above procedures, please
consult your satellite receiver operating guide.
3. The remote control will remember the codes you have
programmed until the batteries are removed from the
remote control. After replacing the batteries repeat the
entire programming procedure as stated above.
4. The INPUT button will act as the TV/SAT button when in
SAT mode.
SATELLITE (SAT) button
This button allows the remote to control your satellite
receiver by setting it to SATELLITE mode.
PRECODED SATELLITE RECEIVER buttons
These buttons transmit the chosen precoded satellite codes.
EXCLUSIVE TV buttons
These buttons are for operating the TV.
Refer to instruction manual of the Satellite Receiver for operation of the buttons exclusively for the Satellite Receiver.
NOTE:
TV
DVD
SLEEP
MY SATELLITE RECEIVER CODE IS:
30
FUNCTIONS
POWER
VCR CBL
SAT
SOURCE WIZARD
AV1 AV2
AV3
1
2 3
4 5 6
7
8 9
0
LAST CH
HELP
SELECT
VOL CH
INFO
PIP PIP CH FREEZE
PIP ACCESS
SWAP
PIP MODE
TV/VCR
PROG SLOW
REC
CLU-577TSI