Using The Remote To Control Vcr Functions - Hitachi 32GX01B, 32UX01S, 36GX01B, 36UX01S Operating Manual

USING THE REMOTE TO CONTROL VCR FUNCTIONS

Operating the precoded function for your VCR.
This remote is designed to operate different types of VCRs. You must first program the remote to match the remote system of your
VCR. (refer to page 31)
1. Turn ON your VCR.
2. Aim the remote control at the front of your VCR.
3. Press the DVD/VCR button to switch to the VCR pre-coded mode.
4. Hold down the DVD/VCR button on the remote, enter the two digit preset code that matches your VCR as shown on page 31.
The remote will turn off your VCR when the correct two digit preset code is entered. When this occurs, the remote control is
programmed for your VCR. If the VCR does not turn off after five seconds, try a different two digit preset code.
5. The remote will now control you VCR.
EXCLUSIVE TV Buttons
These buttons are for
operating the TV.
NOTES:
1. If your VCR cannot be operated after performing the above procedures, your VCR s code has not been precoded into the
remote.
2. In the unlikely event that your VCR cannot be operated after performing the above procedures, please consult your VCR
operating guide.
3. The remote control will remember the codes you have programmed until the batteries are removed from the remote control.
After replacing the batteries repeat the entire programming procedure as stated above.
4. The INPUT button will act as your VCR 100 button if required.
Refer to instruction manual of the VCR for operation of the buttons exclusively for the VCR.
NOTE:
POWER
TV CBL/SAT DVD/VCR
SWAP MOVE
PIP
FREEZE
PIP CH
TV/VCR
HELP
MENU
LAST CH
MUTE
EXIT
VOL CH
1 2 3
4 5 6
7 8 9
0
INPUT SLEEP
REC C.S. RECALL
CLU-431UG
28
VCR button
This button allows the remote to
control your VCR by setting it to
VCR mode.
PRECODED VCR BUTTONS
These buttons always transmit
the chosen precoded VCR codes.