Table of Contents
Advertisement
0348E3.fm Page 5 Tuesday, April 25, 2000 4:15 PM
I
NSTA LLA TION
Remote Control Battery Installation
Batteries: Use two "AA: batteries.
1. Remove the battery compartment cover on back of the remote.
2. Install the batteries in the battery compartment. (Polarity (+) or (-) must be correct.)
3. Reattach the battery cover.
Precaution on Battery Use
Incorrect installation can cause battery leakage and corrosion that will damage the remote control.
Observe the Following Precautions:
1. Batteries must be replaced as a pair.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (Example: "Zinc Carbon" with Alkaline").
4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
5. Battery replacement is necessary when remote control reacts sporadically or stops operating the
television.
Cable / Antenna
For proper reception, either a cable or antenna connection is required.
Cable Connection
Connect the cable supplied by your local cable company.
Note:
A cable converter box may be required for proper reception. Check with your local
Cable company for compatibility requirements.
Antenna Connection
•
For proper reception of VHF/UHF channels, an external antenna is required. For best
reception an outdoor antenna is recommended.
•
Antenna must be selected as the signal source in the SET-UP menu.
Installation
Battery Replacement
For frequent remote users, replace old
batteries with alkaline batteries for
longer life.
Cable Preset
Cable (CATV) mode is preset at the
factory. Antenna users must change to
antenna mode in the Set -Up menu.
- 5 -
Incoming cable from
cable company
75 O
VHF/UHF
HM
TV
ON BACK OF
Incoming cable from
home antenna
Advertisement
Table of Contents
