Pip (Picture In Picture) Button - Hitachi 27UX01B Operating Manual

0348E3.fm Page 14 Tuesday, April 25, 2000 4:15 PM

PIP (Picture in Picture) Button

This feature allows the viewer to monitor one channel program while watching another. The monitored source (PIP) can be
a different channel or a different video source (such as a VCR) when connected to the input jacks.
PIP Operation
1. Press the PIP button (set must be ON). The PIP frame will appear at the position it was last displayed. The main picture
video source and PIP video source will display on screen momentarily. Audio will be that of main picture.
Note: When the Main Picture is in Video mode with no signal, the PIP will not operate properly.
2. Press the PIP button again to size PIP frame or twice to cancel PICTURE IN PICTURE feature.
PIP CH Buttons
Press the PIP CHANNEL p q button while the PIP frame is displayed to sequentially scan through channels.
Special Buttons
PIP
Main Picture
with Audio
PIP VIDEO 1
PIP
Large PIP Frame
q
PIP CH
Scan Channel Down
(next lower)
- 14 -
CH 2
PIP
Frame
Small PIP Frame
p
PIP CH
Scan Channel Up
(next higher)