Table of Contents
Advertisement
10. Playback
10a. Chase Playback
Chases can be played back in two modes- "Sequence" or "Mix". Sequence mode allows for
chases to be played back one at a time. All eight chases can be selected at one time.
However, the chase with the flashing LED is the only active chase running at the given time.
Once that chase has finished, the next selected chase will automatically begin to run and it's
LED will begin to flash until it finishes. This sequence mode will automatically loop all
selected chases. Mix mode allows up to eight chases to be played back at any one time. This
mode allows for the highest values to take effect over a given channel. For example, if one
chase contains a value of 126 for channel 2 and another chase contains a value of 246 for
channel 2 then the chase containing the value of 246 will take precedence because it is a
higher value.
10b. Sequencing chase playback
1. Press chase buttons 1-8 you wish playback. The active chase LED flash continuously and
the LCD will display the selected chase number followed by the sequencing chase steps-
"C1-8:1-99". (Note: if more than one chase was selected, the chases will continue to
sequence from one to the next in the order they were selected).
2. Press the "SPEED" button to adjust the chase rate. Use the "UP/DOWN" buttons to set
the chase rate ranging from 0.1 (one tenth of a second) to 10:00 (ten minutes).
3. Press the "FADE" button to adjust the chase fade time. Use the "UP/DOWN" buttons to
set the fade time ranging from 0.1 (one tenth of a second) to 10:00 (ten minutes).
4. To disengage a chase, press the chase button you wish to turn off. The chase buttons
LED will turn off confirming that it will no longer be included in the sequence.
10c. Mix chase playback
1.
Press and hold down any recorded chase button 1-8, then select other chases you want
included in your mixed chase playback. All selected chases will then flash continuously
indicating that they are part of the mixed chase playback.
2.
Press the "SPEED" button to adjust the chase rate. Use the "UP/DOWN" buttons to set
the chase rate ranging from 0.1 (one tenth of a second) to 10:00 (ten minutes).
3. Press the "FADE" button to adjust the chase fade time. Use the "UP/DOWN" buttons to set
the fade time ranging from 0.1 (one tenth of a second) to 10:00 (ten minutes).
4. Press any chase button twice to exit mix chase mode.
10d. Show Playback
Shows can be played back in two modes- "Sequence" or "Mix". Sequence mode allows for
shows to be played back one at a time. Both shows can be selected at one time. However,
the show with the flashing LED is the only active show running at the given time. Once that
show has finished, the next selected show will automatically begin to run and it's LED will
begin to flash until it finishes. This sequence mode will automatically loop both shows
continuously. Mix mode allows both shows to be played back at any one time. This mode
allows for the highest values to take effect over a given channel. For example, if one show
contains a value of 161 for channel 3 and the other show contains a value of 223 for channel
3 then the show containing the value of 223 will take precedence because it is a higher value.
This mode works very well with moving lights.
8
Advertisement
Table of Contents
