Assembling Your Torso Developer Plus - Weider TDPWM0 User Manual

Assembling the TORSO DEVELOPER PLUS
Place all parts of the TORSO DEVELOPER PLUS in a cleared area and remove the packing materials. Do not
dispose of the packing materials until assembly is completed.
Assembly requires the included hat cap tool
wrench and hammer
1. Using a hammer, lightly tap a Hat Cap (8) onto
one end of the Roller Axle (7).
Insert a Roller Bushing (6) into each Roller (5).
Place the Rollers on both sides of the Ab Bar
(4). Slide the Roller Axle (7) through the Roller
Bushings and the Ab Bar. Using the included
hat cap tool, secure another Hat Cap (8) to the
Roller Axle.
2. Slide the Bungee Assembly (9) into the Bungee
Tube (1) as shown. Be sure to insert the
Bungee Assembly into the end of the
Bungee Tube with the small holes. The tabs
on the Bungee Assembly should snap into
the small holes. Slide the Outer Bushing (12)
onto the other end of the Bungee Tube.
3. The help of another person is recommended for
this step.
Place the Split Bushings (3) over the Bungee
Tube (1). Line up the notches in the Split
Bushings so they hold the bungee cords. Align
the holes in the Split Bushings with the large
holes in the Bungee Tube.
Slide the Ab Bar (4) over the Split Bushings (3).
Align the holes in the Ab Bar with the holes in
the Split Bushings and the Bungee Tube (1).
Thread the Bolt (10) through the holes and
tighten the Nut (11) onto the Bolt.
and allen wrench
.
1
6
5
8
2
12
3
4
4
and your own adjustable
4
5
Small
Holes
1
Large
Holes
Bungee
3
Cords
10
1
3
11
6
7
8
9