Displaying Multi Picture - Hitachi 37PD5000 User Manual

OPERATING INSTRUCTIONS (continued)
PinP button
RGB 1
AV1
AUTO
MENU
ID
2 Pictures (Split)
Input terminal
Sub
Main
PAL, SECAM
AV1
~AV4
NTSC3.58/4.43
576i, 576p
480i, 480p
AV1
1080i/50
AV2
1080i/60
720p/60
RGB1 STB
RGB2 Component
NOTE
• Even if the input of the horizontal / vertical synchronizing signal (or video signal) stops in the MULTI PICTURE display, the mode will not
change to power save mode.
• Please be careful since image retention will occur if display is left in a MULTI PICTURE display state for a long period of time.
Input Signal Screen Display
The input signal status can be displayed on the screen
by pressing the RECALL button of the remote control or
the monitor.
• The display will go out in approximately 6 seconds.
34
RECALL button
VOL
RGB 2 MUTE VOL
RECALL button
AV2 AV3 AV4
PinP SIZE RECALL
OK
RETURN button
ID SET
AV1~AV4
PAL NTSC3.58 576i
SECAM NTSC4.43 576p

Displaying MULTI PICTURE

If the PinP button on the remote control is pressed MULTI
PICTURE will display.
Activating the P-in-P mode from the RGB input screen
Pressing the PinP button one time will display 2 pictures.
• This mode can be available from RGB1(DVI-PC) and RGB2(RGB)
input.
• The speaker icon can be shifted up and down by pressing the
and SELECT buttons; the audio of the video will be output from
the side on which the speaker icon
is located.
• The sub-screen position can be
selected up and down by pressing
SELECT buttons.
• The sub-screen can be selected with
the AV1, AV2, AV3, and AV4 buttons
from the status that the speaker icon
appears on the left side of AV
shown in the diagram to the right.
• Pressing the PinP button again or the RETURN button will cancel
the 2 pictures display.
• "Frequency Mode" in the Setup Menu should be set to Movie when
sub-screen is the component signal of 1080i/50 or 1080i/60.
Activating the Split mode from the video input screen
Pressing the PinP button one
time will display 2 pictures.
• The speaker icon can be shifted left
and right by pressing the
SELECT buttons; the audio of the
video will be output from the side on
which the speaker icon is located.
• The same video input mode cannot
be selected for both screens at the same time.
• Pressing the PinP button again or the RETURN button will cancel
the 2 pictures display.
• When the Video input is set to RGB Video, this Split mode is not possible.
• Refer to the table for 2 pictures (Split) mode.
AV1, AV2
480i
1080i/50 1080i/60 720p/60
480p
VIDEO
Off-timer
On-timer
RGB2
AV1
✱
as
AV1: Displays the VIDEO input signal of the sub-screen.
and
RGB1 RGB2
STB Component
Main
( : Available)
Composite
-- -- Min.
OFF
-- -- : -- --
(Sub-
screen)
AV1 AV2
Sub
Input mode
AV1
Signal mode