What To Do If - Zanussi ZYB594 User Manual

2
1
7
Carefully lift (step 1)
and remove (step 2) the
panels of glass one by
one. Start from the top
panel of glass.
Clean the glass panels with water and soap. Dry the glass
panels carefully.
Installing the door and the glass panels
When the cleaning is completed, install the glass panels
and the oven door. Do the above steps in the opposite se-
quence.

What to do if...

Warning! Refer to "Safety information" chapter.
Problem
The appliance does not heat
up.
The oven lamp does not oper-
ate.
Steam and condensation col-
lect on the food and in the ap-
pliance.
16
Possible cause
The appliance is deactivated.
The clock is not set.
The necessary settings are not set.
The automatic switch-off is on.
The Child lock is on.
The fuse in the fuse box is released.
The oven lamp is defective.
You left the dish in the appliance for too
long.
Make sure that you put the
glass panels back in the
correct sequence.
The middle panels have a decorative frame. When you in-
stall the middle panels, make sure that the screen-printing
zone looks to the inner side of the door. Make sure that
after the installation the surface of the glass panel frame
on the screen-printing zones is not rough when you touch
it.
Activate the appliance.
Set the clock.
Do a check of the settings.
Refer to "Automatic switch-off".
Refer to "Deactivating the Child Lock".
Do a check of the fuse.
If the fuse is released more than one
time, contact a qualified electrician.
Replace the oven lamp.
Do not let the dishes stay in the appli-
ance for longer than 15-20 minutes after
the cooking is completed.
Make sure that you install
the top panel of glass in
the seats correctly.
Remedy