Troy-Bilt TB 672 Operator's Manual page 7

Attaching the Chute Attachment
WARNING!
DO NOT operate without shields and
guards (e.g., discharge chute, air intake guard) in
place.
To redirect airflow at a 90 degree angle during operation, a chute
attachment is included with your jet sweep blower.
1. Pivot the blower direction lever all the way to the right, into
the highest position. See Figure 3-3.
2
Figure 3-3
2. Slide the chute attachment downward, over the opening.
3. Pivot the direction lever to the middle position to lock the
chute attachment in place. See Figure 3-3.
WARNING!
Keep hands out of inlet and discharge
openings while machine is running. There are
rotating blades inside.
1
3
Set-Up
Adding Fuel
Refer to the Engine Operator's Manual packed with your jet
sweep for information on adding fuel.
WARNING!
Use extreme care when handling
gasoline. Gasoline is extremely flammable and the
vapors are explosive. Never fuel the machine
indoors or while the engine is hot or running.
Extinguish cigarettes, cigars, pipes and other
sources of ignition.
Adding Oil
Refer to the Engine Operator's Manual packed with your jet
sweep blower for information on adding and checking oil.
CAUTION:
Always check the engine oil level before
each use as instructed in the Engine Operator's
Manual. Add oil as necessary. Failure to do so may
result in serious damage to your engine.
S
ection
3 — A & S -U
SSembly et p
7