Playback - Hitachi VM-8400LA Instruction Manual

PLAYBACK

PLAYBACK
You can view recorded pictures on the 3-inch LCD monitor immediately after recording.
• If you connect the camcorder to your TV, you can see the picture played back on your TV.
Open the LCD monitor, and then adjust the angle of the monitor
2. Press and hold the small button on "CAM/OFF/ VIDEO", and then slide it to the "VIDEO"
position.
3. Press "REW/REVIEW" to the position where you want to start playback.
4. Press "PLAY" and play back the tape.
To adjust the volume, adjust the volume control at the bottom of the camcorder.
NOTE: Adjust TRACKING if necessary.
5. Press "STOP/EJECT" when you have finished.
NOTES:
• Decrease the sound volume of the camcorder when you play back a recording by connecting
the camcorder to your TV. lf the volume of the camcorder is set to maximum, the played back
picture may be distorted. Make sure that the volume is not set to maximum during recording as
it could distort the played back picture.
• When the LCD monitor is turned on and left as it is, the monitor becomes warm, but this does
not indicate a fault.
• When "CAM/OFF/VIDEO" is set to "CAM" or "VIDEO", the LCD monitor is turned on and off
automatically when the LCD monitor is opened and closed.
• It is recommended that you close the LCD monitor to save the battery power when playing
back a picture on a TV or recording a TV program without viewing it.
• Only the playback sound is heard. The sound being recorded is not heard.
To play back a tape with the viewfinder
• Close the LCD monitor, then press "PLAY" to play back the tape. The picture appears in the
viewfinder.
25