Recording Using Led Light (For Dz-Gx5040E Only) - Hitachi DZ-GX5040E Instruction Manual

Recording using LED Light
(for DZ-GX5040E only)
You can use the LED light to illuminate a subject to be recorded in a dark place.
1
Press the button during recording pause or recording.
An icon will appear on the screen, and the LED light will glow.
LED light icon
FINE
2
Press the button again.
The LED light will go out.
:
Note
• Pressing will turn the LED light on and off
alternately.
• The LED light will go out if you perform the following:
- Display the Disc Navigation screen.
- Start playback.
- Switch to demonstration mode.
• Recording with LED light on will shorten the battery
life more than recording with LED light off.
• Do not turn the LED light on with your eyes near it.
Also, be sure not to look directly into the light emitting
portion when the LED light is on: Doing so could
cause visual disorder, such as decreased sight. And
especially: Do not record small children at close-up
distance with the LED light turned on.
• Do not use the LED light while pointing at a driver in
vehicle: Doing so could dazzle the driver, causing an
accident.
• Do not use the LED light in a place where there is
flammable or explosive gas: Doing so could cause fire
or explosion.
• Do not block the light emitting portion when the LED
light is turned on: Doing so could generate heat.
• Do not display the LED light beam reflected on a
mirror, etc. on TV screen: Doing so could cause
burning of screen.
• Once you press the
on, it will remain on until the
again, which is different from the conventional flash.
• When using the LED light for recording, set the
distance to subject at no more than 1.5 m.
0 : 0 0 : 0 0
REM 3 0 MIN
8 : 0 0
1 0 / 2 / 2 0 0 7
button to turn the LED light
button is pressed
LED light
45