Basic Techniques; Recording Movie - Hitachi DZ-GX5040E Instruction Manual

Basic Techniques

This section explains about recording of movies and still images, and also basic settings on
DVD video camera/recorder.

Recording Movie

Before You Begin
Pressing REC
once will start
ACCESS/PC
recording;
indicator
pressing it once
again will
temporarily stop
recording.
1
Remove the lens cap, and then point the DVD
video camera/recorder at subject.
2
Turn the DVD camera/recorder on.
Set the power switch to " " to turn the DVD
video camera/recorder on.
After the ACCESS/PC indicator goes out,
perform the subsequent operation:
3
Check the subject on the screen (viewfinder
or LCD).
When using the viewfinder, close the LCD
monitor before pulling out the viewfinder.
4
Press the REC button.
The " " mark in the viewfinder or on the
LCD screen will change to the "
and recording will start.
During recording, the recording indicator on
the front of DVD video camera/recorder will
light.
Pressing REC again during recording will set
the DVD video camera/recorder to the
recording pause status.
5
When recording is finished, turn the DVD
video camera/recorder off.
42
• Insert a recordable disc into this DVD video camera/recorder.
" mark,
:
Note
• See "Troubleshooting" on page 137 when recording
movie is not possible.
• See "Troubleshooting" on page 137 if it takes some
time before recording is possible.
• See "Troubleshooting" on page 137 if the DVD video
camera/recorder does not operate.
• See page 46 for on-screen information display.
• While the ACCESS/PC indicator is lit or blinking, do
not turn the DVD video camera/recorder off, and take
care not to subject it to any vibration: Doing so could
cause an error in the recorded data, which could
make it unplayable (see page 8).
• The minimum recordable time of movie is
approximately 3 seconds.
• See page 36 for setting of Record LED (recording
indicator) On/Off.
• For various functions available during recording, see
"Setting Up Camera Functions" on page 59.
• Hitachi cannot be responsible for video and audio that
cannot be recorded or edited because of any defect.
• The power switch can be changed over even during
recording, but the operation will not be changed.
• It is recommended that you set the LOCK switch to
(the upper position) to prevent the power switch in the
" " position from accidentally moving to " " position.
• Each time the DVD video camera/recorder enters the
recording pause status, the counter display will be
reset to "0:00:00".
• If, when using a +RW, one-time recording duration is
short or you frequently switch the video quality,
recording may not be possible even when the disc
has remaining space.