Hitachi DZ-GX5040E Instruction Manual page 133

Message
Card error has
occurred.
Formatting is not
complete.
Card error has
occurred. Keep card
inside & restart.
Card full.
Card is not formatted.
Format the card now?
CHECK DISC
Control Information
Error.
DISC ACCESS
DISC ALMOST FULL
Disc error has occurred.
Finalizing is not
complete.
Disc error has occurred.
Format the disc now?
Disc error has occurred.
Formatting is not
complete.
Disc error has occurred.
Keep disc inside &
restart.
Disc error has occurred.
Unfinalizing is not
complete.
Cause & Troubleshooting
The card may be damaged: Use another card.
Card error could have occurred during editing of scenes. Turn off
the DVD video camera/recorder with the card being used inside,
connect the AC adapter/charger, and then power the DVD video
camera/recorder again.
Delete unnecessary stills and try the card, or use another card.
Was the card formatted on PC? When using the card on this DVD
video camera/recorder, choose "YES" and format it.
A disc unusable on this DVD video camera/recorder may have
been inserted or the disc may be damaged.
Make sure that the type of disc is correct, and make sure that the
disc is not write-protected.
Mismatch may occur between the recorded image and scene
information.
Update the control information.
• Use another disc.
• See *3 and *4 on page 137.
The recorded scene is being stored on disc.
This DVD video camera/recorder is verifying whether the correct
disc has been inserted.
Wait until the message disappears, and you can start to use the
DVD video camera/recorder.
The remaining free space of disc is less than one minute for
video: Delete unwanted scenes, or use another disc.
• Disc error occurred during finalising, and finalising failed.
Replace the disc.
• See *3 on page 137.
• Has the disc been initialised on PC? Has initialising the disc on
PC been interrupted?
Choose "YES" and initialise the disc when using it on this DVD
video camera/recorder. Initialising the disc will erase all data on
it.
• See *2 on page 136.
The disc may be dirty.
Remove the disc and wipe off fingerprints, dust, etc. before
reusing it, or use another disc.
This message may also appear if you insert a disc for which
formatting was interrupted midway. In this case, use another disc.
Disc error could have occurred during editing of scenes.
Turn off the DVD video camera/recorder with the disc being used
in it, connect AC adapter/charger, and then power the DVD video
camera/recorder again. Repair of scenes will be tried.
This message will appear when disc error occurred during
unfinalisation, and unfinalising disc failed. Replace the disc.
Reference
page
26
27, 32
80, 149
100
26, 101
102
11, 25
42, 43
39
80, 148
103
100
11, 100
27
104
133