Kolcraft Universal 2 Car Seat Carrier Instruction Sheet page 5

2
3
4
1
Tab locks into hole
3
To Assemble Front Wheels
Tab
To Assemble Rear Wheels
5
Remove any cardboard inserts or plastic
1
ties used to protect the product during
shipment.
Turn Carrier over as shown.
2
Align front wheel assembly as shown.
3
Tab must be facing away from pin
(towards you).
Push wheel assembly onto pin until it
4
snaps into place.
Repeat for other wheel. Tug firmly on
5
each wheel assembly to be sure
assemblies are securely in place.
NOTE: To remove front wheels, pull tab
and lift wheel off.
Position complete rear axle assembly
1
with brakes as shown, with brake levers
pointing towards Carrier handle.
Push both brake assemblies onto rear
2
leg tubes at the same time.
Make sure plastic tabs on brake assem-
3
blies lock into holes on rear legs as
shown.
Line up tabs in each of the hub caps
4
with slots in the wheel, snap hub caps
into place.