Removal Of The Lamp Power Unit; Removal Of The Filter Pcb Assy And Inlet Pcb Assy - Mitsubishi Electric LC62 CHASSIS XL6500LU Service Manual

17. Removal of the lamp power unit

1. Remove the terminal cover ASSY according to "1.
Removal of the terminal cover ASSY".
2. Remove the front case unit and top cover unit ac-
cording to "3. Removal of the lens unit and zoom fo-
cus motor".
3. Remove the top case unit according to "4. Removal
of the top case unit and KEY PCB ASSY".
4. Remove the tspeaker according to "8. Removal of the
speaker".
5. Remove the main barrier according to "9. Removal of
the power fan".
6. Remove the terminal ASSY according to "11. Remov-
al of the TERMINAL PCB ASSY".
7. Remove the DRIVE PCB ASSY according to "12. Re-
moval of the DRIVE PCB ASSY and LCD block ".
8. Remove the drive PCB holder according to "13. Re-
moval of the drive fan".
9. Disconnect the lamp power lead and thermostat con-
nector according to "15. Removal of the optical unit".
10. Remove the power box T unit according to "16. Re-
moval of the POWER PCB ASSY".
11. Remove the power fi n as shown in Fig. 3-13.
12. Release the two hook (a) as shown in Fig. 3-13.
13. Remove the lamp power unit as shown in Fig. 3-13.
18. Removal of the FILTER PCB
ASSY and INLET PCB ASSY
1. Remove the terminal cover ASSY according to "1.
Removal of the terminal cover ASSY".
2. Remove the front case unit and top cover unit ac-
cording to "3. Removal of the lens unit and zoom fo-
cus motor".
3. Remove the top case unit according to "4. Removal
of the top case unit and KEY PCB ASSY".
4. Remove the speaker according to "8. Removal of the
speaker".
5. Remove the main barrier according to "9. Removal of
the power fan".
6. Remove the terminal ASSY according to "11. Remov-
al of the TERMINAL PCB ASSY".
7. Remove the DRIVE PCB ASSY according to "12. Re-
moval of the DRIVE PCB ASSY and LCD block ".
8. Remove the drive PCB holder according to "13. Re-
moval of the drive fan".
9. Disconnect the lamp power lead and thermostat con-
nector according to "15. Removal of the optical unit".
10. Remove the power box T unit according to "16. Re-
moval of the POWER PCB ASSY".
11. Remove the screw (a) as shown in Fig. 3-14.
12. Lift the FILTER PCB ASSY and disconnect the con-
nector (PP) as shown in Fig. 3-14.
13. Remove the FILTER PCB ASSY as shown in Fig.
3-14.
14. Remove the screw (b) and screw (c) as shown in
Fig.-3-14.
15. Remove the INLET PCB ASSY as shown in Fig.
3-14.
bx1
- 28 -
Power fin
Lamp power unit
ax2
Fig. 3-13
INLET PCB ASSY
FILTER PCB ASSY
cx1
Fig. 3-14
ax1
PP