Turning On The Unit; Initial Setup - Kenwood DNX9210BT Instruction Manual

Return to the Top page
Basic Operations
T
urning On The Unit
The method of turning on is different depending on the model.
1
Press the <MENU> button.
The unit is turned on.
● To turn off the unit:
●
Press the <MENU> button for 1 second.
If it is your first time turning the unit on after installation, it will be necessary to perform

Initial setup

(P.8).
Initial setup
Perform this setup when you use this unit first time or when you reset the unit (P.99).
1
Set each item as follows.
Language
Select the language used for the control screen and setting items. Default is "British English (en)".
1 Touch [SET].
2 Touch [2] or [3] to select the desired language.
3 Touch [Enter].
For detailed operation, see Language setup (P.71).
8 8
Angle
Adjust the position of the monitor. Default is "0".
1 Touch [SET].
2 Touch desired angle number and [ ].
For detailed operation, see Monitor angle control
iPod AV Interface Use
Set the terminal which your iPod is connected to. Default is "iPod".
1 Touch [iPod] or [AV-IN2].
Color
Set the screen and button illumination color. You can select whether to allow color scan operation or
select a fixed color for operation.
1 Touch [SET].
2 Touch [ON] or [OFF] of [Panel Color Scan].
3 If you want to change color, touch [SET] of [Panel Color Coordinate].
4 Touch your desired color and [ ].
For detailed operation, see Panel color coordinate
EXT SW
Control the external devices.
1 Touch [SET].
2 Set device name, output pattern, and pulse set for device. Then, touch [
For detailed operation, see EXT SW setup (P.73).
Camera
Set the parameters for the camera.
1 Touch [SET].
2 Set each item and touch [ ].
For detailed operation, see Camera Setup (P.78).
2
Touch [Finish].
NOTE
These settings can be set from the SETUP menu. See Setting Up
•
Return to the Top page
Basic Operations
(P.74).
(P.75).
].
(P.68).
9