Connecting An External Device Device Equipped With Scart-Out - TerraTec Cinergy 200 TV Installing Hardware And Drivers

Connecting an external device device equipped with Scart-out.

If you want to connect a device that is equipped with a Scart-out jack, you will need a special
adapter for establishing the connection to the TV card.
The required adapter has a Scart jack on one side, which you plug into the external device,
and three cinch jacks on the other. The three cinch jacks provide the video, audio-left and
audio-right signals. Furthermore, to connect the audio-left and audio-right cable to the Line-in
jack of your sound card, you will have to have a Y cable.
Connect the cable to the TV card as described below:
1. Using a cinch/cinch cable, connect the cinch jack that carries the video signal (usually
yellow) to the composite-in jack on the TV card.
2. Connect the audio-left (usually white or black) and audio-right (usually red) jacks with the
corresponding cinch jacks on the Y cable.
3. Plug the stereo jack of the Y cable into the Line-in input of your sound card.
4. In the TV software, select the "Composite" option as incoming signal.
Note: When using the composite video input, be sure to read the section entitled "Attention! -
Establishing the audio connection to the TV card." on page 23.
When purchasing an adapter, check the signal direction that it is designed for. There are
adapters designed for sending signals into the video device (video-in), and those that are
designed for signals being sent by the video device (video-out). In this case, you want an
adapter with a video-out signal direction! To be certain of your purchase, you may want to buy
22
Scart adapter
Y cable
Cinergy TV Hardware (English)