Advertisement
BaSiC TrouBleShooTiNg
6. Problem:
Console shuts off (enters sleep mode) while in use
Solution:
A. Check data cable integrity. All wires in cable should
be intact. If any are crimped or cut, replace cable.
B. Check data cable connections/orientation. Insure
cable is connected securely and oriented properly.
Small latch on connector should line up and snap into
place.
C. Reset Machine (if equipped with reset button).
Unplug unit from electrical outlet for 3 minutes.
Reconnect to outlet and after console powers up press
"reset" .
D. Check magnet position (requires shroud removal).
Magnet should be in place on flywheel. If no magnet
present, replace flywheel or entire base unit.
E. Check RPM Sensor (requires shroud removal). RPM
sensor should be aligned with magnet and connected
to data cable. Re-align sensor if necessary, replace if
any damage to sensor or connecting wire.
Advertisement
