Table of Contents
Advertisement
Cooling Your Room
10
E
-
You must select the Cool mode if you wish to adjust the:
N Cooling temperature
N Fan speed when cooling
1
If necessary, press the
Result:
N
The operation indicator on the indoor unit lights up.
N
The air conditioner starts up in the mode selected
when the unit was last used.
N
The indoor unit beeps.
The air conditioner is fitted with protection mechanism
IMPORTANT
to prevent the unit from being damaged when it is started
immediately after being:
N
Plugged in
N
Stopped
lt will start up normally after three minutes.
2
If the
is not displayed at the top of the remote control,
press the
button on the remote control one or more times until it
appears.
Result:
N The indoor unit beeps each time you press the
N
The air conditioner runs in the Cool mode.
Note
You can change modes at any time.
3
To adjust the temperature, press the
the required temperature is displayed.
Possible temperatures are between 16°C and 30°C inclusive.
Result:
N
Each time you press the
- The temperature is adjusted by 1°C
- The indoor unit beeps
N The air conditioner starts cooling, provided that the room
temperature is higher than the selected temperature.
N If the room temperature reaches the set temperature, the air
conditioner stops cooling, but the fan is still operating.
4
Select the fan speed by pressing the
until the required setting is displayed:
Automatic (rotated :
Low
Medium
High
Result:
Each time you press the
5
To control the direction of the air flow, refer to page 15.
button.
button one or more times until
button:
button one or more times
¬
¬
)
button, the indoor unit beeps.
button.
Advertisement
Chapters
Table of Contents
