Cleaning The Lint Filter - Fisher & Paykel AeroSense Installation Instructions And User Manual

Cleaning the lint filter

12
AeroSense™ and AeroLogic™ dryers
It is important to clean the lint filter after every
load, as the lint produced in the drying process
can become a fire hazard if it is allowed to
accumulate in or around your dryer.
The lint filter is located in the door opening.
Remove the lint filter, open it out and wipe
1
clean with your hand.
Close the lint filter and place it back in the
2
opening.
AeroDry™ dryer
The lint filter is located on the door of the dryer
behind the directional outlet grill. Lint should be
removed from the filter after every load.
To remove the outlet grill grasp the hub in the
1
centre of the grill and pull. Wipe the filter clean
with your hand.
To replace the grill, locate the hub over the boss
2
in the centre of the door and push firmly.
Note: do not clean your lint filter by vacuuming
or wetting it, as this may block the fine pores
essential for maximum airflow.
Fig. 13 Lint filter – AeroSense™ and
AeroLogic™ dryers
Fig. 14 Lint filter – AeroDry™ dryer