Troubleshooting - Meridian G61R Installation Manual

We expect you to achieve superb results with your digital surround controller. If, however, you
encounter any problems, either when installing and configuring it, or during operation, please
If these suggestions fail to cure the problem, please contact your Meridian dealer for further
General operating problems
Standby light not lit
• Check that the AC power supply is connected correctly.
• Check that the ON OFF switch on the back panel is in the ON
position.
If the light still does not illuminate, check any fuses in your power
supply and the fuse in the inlet of the G61R. If these are all intact,
contact your dealer.

Troubleshooting

check the following pages for suggested solutions.
assistance.
Erratic or unexpected system behaviour
Redo the Auto Configure process as follows:
• Put the whole system into standby.
• Make sure you are operating the MSR+ from a position where all
the units can receive the infra-red.
• Press Clear on the MSR+.
• Observe all units responding correctly.
In extreme cases, the memory of the G61R may have been
corrupted. If this is suspected perform a full reset; see Resetting the
product , page 18.
 
Tr o u b l e s h o o t i n g