Standard Parameters - Meridian G61R Installation Manual

 
D S P p r e s e t s

Standard parameters

All DSP presets (except Mono and Direct) provide the following
standard parameters.
Individual DSP presets provide additional parameters, to allow you
to adjust specific features provided by that preset. For full details
refer to information about each preset later in this chapter.
Parameter
Treble*
Bass*
Phase*
Axis†
Balance
HS Output?*
Centre
Depth
Rear
Sides
R Delay
S Delay
LipSync
RC
*These parameters apply to all DSP presets.
†Axis is only available with Meridian DSP loudspeakers.
Range Default
-10dB to +10dB +0dB
-5dB to +5dB +0dB
+ or - +
-2 to +3 -1
<10 to 10> <0>
Y or N Y
-3.0dB to +3.0dB +0.0dB
-2.5ms to +5.0ms +0.0ms
-30dB to +10dB +0dB
-30dB to +10dB +0dB
0ms to 30ms Varies
0ms to 30ms Varies
0ms to 30ms 0ms
As defined Bypassed
What it changes
The slope of the frequency response.
The bass response.
The phase of all loudspeakers.
The vertical balance.
The L-R balance.
Select Y for high-rate audio, upsampled if necessary. Select N for
standard-rate audio, downsampled if necessary.
The level of the centre.
The delay of the centre.
The level of the rears.
The level of the sides.
The delay of the rears.
The delay of the sides.
The sync. delay.
The Room Correction profile, or Bypassed for no room correction.