Stage 4: Configuring Other Settings - Meridian G61R Installation Manual

 
C o n f i g u r i n g t h e
d i g i t a l s u r r o u n d

Stage 4: Configuring other settings

c o n t r o l l e r
The next stage allows you to configure other aspects of the
product's operation.
To configure other settings
Either:
• Press Next after configuring the sources; see page 22.
Or:
• Press Wizard; see page 17.
• Press Skip to skip past the stages 1 to 3.
The display shows the title screen for stage 4:
• Press Enter to proceed or Skip to go to the calibration
procedure.
The first setting is displayed:
A description of each setting is shown on the top line of the
display, and its current value is shown to the right of the display.
The settings are summarised in the table on the next page.
To change a setting
• Press A or V to step through the alternative values for the
setting.
To calibrate the system
When you have finished configuring the settings:
• Press Next to proceed to calibrating the system, as described in
the next chapter.
Alternatively, to return to standby:
• Press On/Off.