Meridian G61R Installation Manual page 16

 
I n s t a l l i n g t h e
d i g i t a l s u r r o u n d
c o n t r o l l e r
To connect the G61R to Meridian DSP loudspeakers (home run)
This is an alternative to the "daisy chain" wiring configuration
shown in the previous section.
The G61R automatically assumes that the main left speaker is the
master, unless it is analogue, in which case the DSP centre, left
side, or left rear is used in order of priority (unless explicitly set
differently in the Meridian Configuration program).
• Connect the appropriate SpeakerLink output on the lower row
of the G61R to the master digital speaker (typically the main left
speaker), using a Meridian SpeakerLink lead.
G61R Digital Surround Controller
SPEAKERLINK
OUTPUTS
DSP Loudspeaker – Main Left (Master)
SPEAKERLINK
INPUT OUTPUT
SPEAKERLINK LEAD
DSP Loudspeaker – Centre (Slave)
SPEAKERLINK
INPUT OUTPUT
SPEAKERLINK LEAD
DSP Loudspeaker – Rear Left (Slave)
SPEAKERLINK
INPUT OUTPUT
SPEAKERLINK LEAD
• Connect the appropriate SpeakerLink outputs on the G61R to
each of the remaining speakers, using a Meridian SpeakerLink
lead.
The speakers should then be configured appropriately as master
and slaves, and Left, Right, Centre, Surround; see Meridian DSP
Loudspeaker User Guide for more details.
Alternatively you can use standard CAT5 network cables instead of
SpeakerLink leads.
DSP Loudspeaker – Main Right (Slave)
SPEAKERLINK
INPUT OUTPUT
DSP Subwoofer – Sub (Slave)
SPEAKERLINK
INPUT OUTPUT
DSP Loudspeaker – Rear Right (Slave)
SPEAKERLINK
INPUT OUTPUT