Configuring The Digital Surround Controller; Configuration Wizard - Meridian G61R Installation Manual

Configuring the digital surround controller

This chapter explains how to configure the digital surround controller using the Configuration Wizard.
Alternatively, for complete control over all aspects of the product's configuration you can set up the unit
from a computer using the Meridian Configuration Program. For full information refer to the Meridian

Configuration Wizard

The Configuration Wizard leads you through the correct
sequence to configure your digital surround controller. Alternatively,
you can skip between the configuration stages, which allow you to
reset the configuration, or configure the sources or other settings
of the digital surround controller.
To run the Configuration Wizard
• If necessary press On/Off to put the digital surround controller
into standby.
• Press More.
If the product is locked the display shows:
• Press Unlock to unlock it, then press More.
Configuration Program Guide available separately.
The displays then shows:
• Press Wizard.
Follow the sequence of configuration stages described in the
following pages, pressing Next to proceed after each stage.
At any stage in the Configuration Wizard the following options are
available:
To do this
Go back to an earlier configuration option
Return to the title screen for the stage
Exit from the configuration menus
Display help about the current option
C o n f i g u r i n g t h e
d i g i t a l s u r r o u n d
c o n t r o l l e r
Press
Back
Home
On/Off
More