Meridian G61R Installation Manual page 34

 0
C a l i b r a t i n g
t h e s y s t e m
• Use > and < to move between each of the speakers in the
layout.
The display shows the speaker being tested, and the distance:
• Use A and V to change the distance.
• You can press Units to change between feet/inches and metres.
Repeat this for each of the speakers in your layout.
• Press > to proceed to the next calibration stage.
Fine tuning
These tests allow you to fine-tune the phase and delay of each
speaker when used in conjunction with other speakers on the
layout.
• Use > and < to move between each of the speakers in the
layout.
The first display allows you to adjust the phase. For example:
Press More for help
Left Distance 18'0
Units ìî ïñ óòô öõú
Press More for help
Left Phase
ìî ïñ óòô öõú
The next display shows the distance for the same speaker. For
example:
Left
• Choose the correct setting as follows:
Setting What it sounds like
Correct The sound between the speakers is very even, and
does not change radically as you move your head.
Incorrect The sound appears diffused, and changes in timbre
and apparent location as you move your head.
Pay particular attention to the centre channel, as this can have a
dramatic effect on the overall sound.
• Press > to proceed to the next calibration stage.
+
Press More for help
Distance 18'0
ìî ïñ óòô öõú