Impex IGS-5100 Owner's Manual page 28

STEP 4 (See Diagram 4)
A.) Insert two Ø ½" Bushings (#52) into the holes on the Seat Bracket (#5) and align the holes to
the pivot on the Main Seat Support (#1).
B.) Attach the two Backrest Supports (#10) to the Seat Bracket and align the holes. Secure them
with a M10 x 7 ¼" Allen Bolt (#43), two Ø ¾" Washers (#39), and one M10 Aircraft Nut (#50). Do
not over tighten the Nut and Bolt. Make sure the Backrest Supports are able to swivel.
C.) Attach the Backrest Incline Support (#7) to the opening on the Main Seat Support. Use the T-
shaped Lock Pin (#15) to secure the Backrest Incline Support at the Last Hole on the end of
Support.
D.) Attach the other end of the Backrest Incline Support (#7) to the Backrest Supports (#10). Align
the holes and secure them with two M10 x 1 ¾" Allen Bolts (#42) and two Ø3/4" Washers (#39).
27