Computer Setting; Adjusting The Viewing Angle - Iiyama ProLite T2234MC User Manual

COMPUTER SETTING

 Signal Timing
Change to the desired signal timing listed on page 22: COMPLIANT TIMING.
 Windows 95/98/2000/Me/XP/Vista/7 Plug & Play
The iiyama LCD monitor complies with DDC2B of VESA standard. The Plug & Play function runs
on Windows 95/98/2000/Me/XP/Vista/7 by connecting the monitor to DDC2B compliant computer
with the Signal Cable supplied.
For installation on Windows 95/98/2000/Me/XP: The monitor Information File for iiyama monitors
may be necessary for your computer and obtained via the Internet, using the address:
 For additional information on how to download the driver for your touch screen monitor,
NOTE
please access the internet site noted above.
 Monitor Drivers are not required in most cases for Macintosh or Unix operating
systems. For further information, please contact your computer dealer fi rst for advice.
 Procedure for turning ON the Power Switch
Turn ON the monitor fi rst, and then the computer.
 Touch screen driver software
Touch screen driver software and system may not start when you start your computer while
touching the screen.
Touch screen driver software may not run due to the power saving function depending on the
BIOS of your computer. In this case, set the power saving function to off.

ADJUSTING THE VIEWING ANGLE

 For optimal viewing it is recommended to look at the full
face of the monitor.
 Hold the panel so that the monitor does not topple when
you change the monitor's angle.
 You are able to adjust the monitor's angle up to 90
degrees upward, 5 degrees downward.
 Do not touch the LCD screen when you change
NOTE
the angle. It may cause damage or break the
LCD screen.
 Careful attention is required not to catch your
fi ngers or hands when you change the angle.
http://www.iiyama.com
90°
5°
BEFORE YOU OPERATE THE MONITOR 9