Radyne QAM256 Installation And Operation Manual page 53

QAM256 Digital Video Modulator and Upconverter
radQAM256TxLatchedMinorAlarm2Status OBJECT-TYPE
radQAM256TxLatchedCommonAlarm1Status OBJECT-TYPE
radQAM256TxLatchedCommonAlarm2Status OBJECT-TYPE
radQAM256TxCarrierStatus OBJECT-TYPE
radQAM256TxInterfaceCardType OBJECT-TYPE
t3t1(8) }
"Shows different available interface card types. SMPT and t3t1 interfaces are not yet implemented."
radQAM256TxOptions OBJECT-TYPE
radQAM256CommonOptions OBJECT-TYPE
TM077 – Rev. 4.0
Bit 2..7=Spares"
::= { radQAM256ModStatus 9 }
SYNTAX INTEGER (0..255)
ACCESS read-only
STATUS current
DESCRIPTION
"Bits 0 ..7 Spares"
::= { radQAM256ModStatus 10 }
SYNTAX INTEGER (0..255)
ACCESS read-only
STATUS current
DESCRIPTION
"Bit 0=Interface hardware fault 1=Fault
Bit 1=M&C Hardware Fault
Bit 2..7 Spares"
::= { radQAM256ModStatus 11 }
SYNTAX INTEGER (0..255)
ACCESS read-only
STATUS current
DESCRIPTION
"Bits 0 ..7 Spares"
::= { radQAM256ModStatus 12 }
SYNTAX INTEGER { off(1), on(2) }
ACCESS read-only
STATUS current
DESCRIPTION
"Shows status of the carrier, on or off"
::= { radQAM256ModStatus 13 }
SYNTAX INTEGER { None(1), g703(2), pasi(3), ecl(4), hssi(5), aasi(6), smpt(7),
ACCESS read-only
STATUS current
DESCRIPTION
::= { radQAM256ModStatus 14 }
SYNTAX INTEGER (0..65535)
ACCESS read-only
STATUS current
DESCRIPTION
"This describes the Tx available options:
Bit 0 = Clock polarity
Bit 1 = Data polarity
Bit 2 = Clock activity
Bit 3 = Data activity
Bit 4 = Data fifo 1
Bit 5 = Data fifo 2
Bit 6 = Tx buffer
Bit 7 = Internal clock
Bits 8..15 = Spares
0 = unavailable, 1 = available"
::= { radQAM256ModStatus 15 }
SYNTAX INTEGER (0..65535)
SNMP MIB
B-
7