Installation Instructions - Planar PXL2251MW User Manual

INSTALLATION INSTRUCTIONS

STAND BASE INSTALLATION
The monitor is supplied complete with a stand.If you prefer to wall mount the monitor,
please follow the instructions on page 21 to remove the stand. Be sure to include the stand
with the monitor if it is necessary to return the unit.
CAUTION
• Put the monitor on a stable surface.The monitor may cause injury or
• Do not give a strong impact to the monitor.It may cause damage.
• Unplug the monitor before removal or installation to avoid electric shock
<Installation>
1. Put a piece of soft cloth on the table beforehand to prevent the monitor from being
scratched. Lay the monitor flat on a table with front face down.
2. Install the Stand-Base to the Monitor.
3. Fix the monitor to the stand by using the screw. Once screw is securely fastened, push
down the knob on the scew.
<Remove>
1. Put a piece of soft cloth on the table beforehand to prevent the monitor from being
scratched. Lay the monitor flat on a table with front face down.
2. Pull up the knob of the scews, and remove the screws and the Stand-Base.
<Stopper pin>
Please stand the monitor up. Push down on the
top face of the stand while slowly pulling out
the stopper pin on the back of the stand. Careful
attention is required as the monitor is sprung
loaded and may expand quickly when removing it.
damage if it falls or is dropped.
or damage.
Push down knob on screw
Stand-Base
Screw for Stand-Base fixing
6